All Greenville zoning districts

RNX-B zoning in City of Greenville

Neighborhood Flex B, City of Greenville

RNX-B allows single-family homes by right with up to 8 dwellings on a lot. Apartments are allowed by right.

Minimum lot
None set
Dwellings per lot
8
Front setback
5 ft
Height limit
32 ft

What a parcel in RNX-B holds

RNX-B sets no minimum lot size or density cap the screen can count from, so the yield comes from the building form: setbacks, height, coverage, and parking. Screen a parcel to test it with your own limits.

Uses

UseStatusSource
Single-family homesBy rightSec. 19-3.2.2 Use Table (row: Single-unit living)
ApartmentsBy rightSec. 19-3.2.2 Use Table (row: Multi-unit living)

Limits

LimitValueSource and notes
Minimum lot sizeNoneSec. 19-2.3.4 (RNX-B district standards)Code lists "None" (no minimum lot area). Lot yield is limited by lot width, dwellings per lot, coverage and setbacks.
Minimum lot width40 ftSec. 19-2.3.4 (RNX-B district standards)Value is for lots with front (primary street) vehicle access; 25 ft for lots with side/rear (alley or side street) access or no vehicle access (Sec. 19-2.11.2.B.3). City lot width is "the length of primary street lot lines bounding a lot", measured along the primary street lot line(s) (Sec. 19-2.11.2.B), not at the building line. Applies to lots recorded after July 15, 2023; up to 10% relief by Sec. 6.2.14.
Density limitNoneSec. 19-2.3.4 (RNX-B district standards)No units-per-acre standard. The cap is per lot; see the dwellings per lot limit.
Dwellings per lot8Sec. 19-2.3.4 (RNX-B district standards)Density is set per lot: max 8 dwelling units per lot (base), 10 with bonus; no units-per-acre standard.
Front setback5 ftSec. 19-2.3.4 (RNX-B district standards)5 ft min, 20 ft max.
Side setback4 ftSec. 19-2.3.4 (RNX-B district standards)
Rear setback4 ftSec. 19-2.3.4 (RNX-B district standards)
Height limit32 ftSec. 19-2.3.4 (RNX-B district standards)
Story limit2.5 storiesSec. 19-2.3.4 (RNX-B district standards)
Lot coverage limit65%Sec. 19-2.3.4 (RNX-B district standards)65% for 0 to 8 units, 70% for 9 to 10 units.
Floor area ratio limitNoneThe Development Code has no floor area ratio standard; intensity is set by height, coverage, build-to and massing.
Parking per apartment1 spacesSec. 19-4.6.2.C.1 (parking table)Minimum. No minimum on lots in a Preservation (-P) overlay or with a landmark or listed historic building (Sec. 19-4.6.2.B.2).

Screen a parcel zoned RNX-B

Search an address or parcel number. The screen loads the parcel, finds its district, removes setbacks, flood zones, and wetlands, and counts lots and apartments with these limits.

Screen a parcel Listing sheets for agents

Other City of Greenville districts

Limits from the City of Greenville Development Code, read November 20, 2026. Source document. Ordinances change and overlays can add limits. Confirm the district and its limits with the City of Greenville Planning and Development office before you rely on them.