All Greenville zoning districts

R-S zoning in Greenville County

Residential Suburban District, Unincorporated Greenville County

R-S allows single-family homes by right on lots of at least 25,000 square feet, up to 1.5 homes per acre. Apartments need a rezoning.

Minimum lot
25,000 sf
Density limit
1.5 per acre
Front setback
30 ft
Height limit
45 ft

What a parcel in R-S holds

ParcelSingle-family lots
2 acres2
5 acres6
10 acres13
20 acres26

A clean parcel with no flood zone or wetland, with 25% of the land kept for streets and open space. Lots are the lower of the minimum lot size count and the density limit. A real parcel loses more to its shape, hazards, and frontage. Screen a real parcel for its count.

Uses

UseStatusSource
Single-family homesBy rightTable 6.1 (row: Dwelling - single-family detached)
ApartmentsNeeds rezoningTable 6.1 (row: Dwelling - multiple-family)

Limits

LimitValueSource and notes
Minimum lot size25,000 sfSec. 5:4.525,000 sf with public water and sewer or public water only; 37,500 sf without public water and sewer (Sec. 5:4.5, also Table 7.1). This is the conventional-subdivision minimum. Under the Open Space Development option (Sec. 7:2) there is no minimum lot size or lot width; density is capped by Table 7.1 instead. (R-S: 1.5 units per acre, 1.0 without public water.)
Minimum lot width30 ftTable 7.3
Density limit1.5 per acreTable 7.1Single-family density under the Open Space Development option (Table 7.1); conventional subdivisions are limited by minimum lot size instead. 1.0 per acre without public water.
Dwellings per lotNoneThe county ordinance sets density per acre.
Front setback30 ftTable 7.3Value is for a residential service street; 40 ft on a collector and 50 ft on an arterial. Measured from the right-of-way; if unknown, measured from pavement edge and increased 10 ft (Sec. 7:3).
Side setback5 ftTable 7.3Residential uses (Table 7.3). Nonresidential uses use Table 7.4 (25 ft side).
Rear setback5 ftTable 7.3Residential uses (Table 7.3).
Height limit45 ftTable 7.3Sec. 7:3.7 lets buildings exceed the district height if side and rear yards increase 1 foot for each 3 feet of extra height.
Story limitNoneThe County Zoning Ordinance regulates height in feet only; no story limit found in Table 7.3/7.4.
Lot coverage limitNoneNo maximum lot coverage standard for this district found in Articles 5 and 7 of the County Zoning Ordinance; site yield is set by setbacks, parking, buffers and stormwater.
Floor area ratio limitNoneThe County Zoning Ordinance has no floor area ratio standard (searched the full text).
Parking per apartmentNoneMultifamily not permitted in this district.

Screen a parcel zoned R-S

Search an address or parcel number. The screen loads the parcel, finds its district, removes setbacks, flood zones, and wetlands, and counts lots and apartments with these limits.

Screen a parcel Listing sheets for agents

Other Greenville County districts

  • R-M14 Multifamily Residential District
  • R-M16 Multifamily Residential District
  • R-M20 Multifamily Residential District
  • R-MA Multifamily Residential District
  • S-1 Services District
  • Unzoned unincorporated, no zoning district

Limits from the Greenville County Zoning Ordinance, read November 20, 2026. Source document. Ordinances change and overlays can add limits. Confirm the district and its limits with Greenville County Zoning Administration before you rely on them.