All Greenville zoning districts

POD zoning in Greenville County

Planned Office District, Unincorporated Greenville County

POD allows single-family homes by right up to 10 homes per acre. Apartments are allowed by right.

Minimum lot
None set
Density limit
10 per acre
Front setback
15 ft
Height limit
45 ft

What a parcel in POD holds

ParcelApartments by density
2 acres20
5 acres50
10 acres100
20 acres200

A clean parcel with no flood zone or wetland, with 25% of the land kept for streets and open space. Lots are the lower of the minimum lot size count and the density limit. A real parcel loses more to its shape, hazards, and frontage. Screen a real parcel for its count.

Uses

UseStatusSource
Single-family homesBy rightTable 6.1 (row: Dwelling - single-family detached)
ApartmentsBy rightSec. 8:2.7Table 6.1 shows P for Dwelling - multiple-family in this district. Requires a conceptual site plan at rezoning and Planning Commission site plan review.

Limits

LimitValueSource and notes
Minimum lot sizeNoneNot on file. Table 7.1 has no POD row. Sec. 8:2.7 makes residential uses "subject to the provisions of the Section 5:6, R-M2 through R-M20" district, which would point to the R-M single-family minimum of 7,500 sf (Table 7.1), but the ordinance does not say so directly. Confirm with Zoning Administration.
Minimum lot widthNoneTable 7.3Table 7.3 lists "None" for POD lot width. The Sec. 8:2.7 reference to Section 5:6 could bring in the Sec. 7:3.9 single-family width of 30 ft, but that is not stated; confirm with Zoning Administration.
Density limit10 per acreSec. 8:2.7
Dwellings per lotNoneThe county ordinance sets density per acre.
Front setback15 ftTable 7.3Table 7.3 lists 15 ft for this district.
Side setback25 ftTable 7.3Sec. 7:3.8: may drop to 5 ft where the adjoining property has the same use.
Rear setback25 ftTable 7.3Sec. 7:3.8: may drop to 5 ft where the adjoining property has the same use.
Height limit45 ftTable 7.3Sec. 7:3.7 lets buildings exceed the district height if side and rear yards increase 1 foot for each 3 feet of extra height.
Story limitNoneThe County Zoning Ordinance regulates height in feet only; no story limit found in Table 7.3/7.4.
Lot coverage limitNoneNo maximum lot coverage standard for this district found in Articles 5 and 7 of the County Zoning Ordinance; site yield is set by setbacks, parking, buffers and stormwater.
Floor area ratio limitNoneThe County Zoning Ordinance has no floor area ratio standard (searched the full text).
Parking per apartment1.5 spacesTable 12.1, item 4Bedroom-based: 1 space per 1-BR or efficiency, 1.5 per 2-BR, 2 per 3+ BR, plus visitor parking equal to 10% of required spaces. 1.5 is the 2-BR ratio; compute from the unit mix. Structures of four units or fewer: 1.5 per unit.

Check with the planning office. Some limits for POD were read from general provisions and carry more doubt than other districts.

Screen a parcel zoned POD

Search an address or parcel number. The screen loads the parcel, finds its district, removes setbacks, flood zones, and wetlands, and counts lots and apartments with these limits.

Screen a parcel Listing sheets for agents

Other Greenville County districts

  • C-3 Commercial District
  • I-1 Industrial District
  • NC Neighborhood Commercial District
  • R-7.5 Single-Family Residential District
  • R-10 Single-Family Residential District
  • R-12 Single-Family Residential District

Limits from the Greenville County Zoning Ordinance, read November 20, 2026. Source document. Ordinances change and overlays can add limits. Confirm the district and its limits with Greenville County Zoning Administration before you rely on them.